22
7019-230C
May 18, 2015
Santa Fe Pellet Insert
Figure 21.1
Shock hazard.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded 3 prong
receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front of appliance.
CAUTION
Junction Box
Cut Away
LEFT SIDE
Junction Box, Front
Power
Cord
Recepticle
Terminal Block
Center 2 Screws
for Thermostat wires or remote
110 Outlet for
Remote
Control Only
(unfused)
Fuse
Red Call
Light
The 110 outlet on the junction box is for a remote con-
trol ONLY. Do not use outlet for any other purpose. It
can damage the appliance and it will void your war-
ranty.
CAUTION
Thermostat Installation (continued)
NOTE: If the thermostat is located too close to the
appliance, you may need to set the temperature
setting slightly higher to maintain the desired tem-
perature in your home.
3.
There is a 4 screw terminal block located on the junction
box to the right of the power cord inlet. The center 2
screws are for the thermostat wires. The outer 2 are the
mounting screws for the terminal block.
Figure 21.1.
Figure 21.1
Figure 21.2
I. Optional Log Set Placement
Two Piece Log Set Installation
1. Open door to expose the fi rebox.
2. Install the left log fi rst and then the right log.
Figure 21.1
3. Lean the logs against the cast iron brick in the back of
the fi rebox.
4. Push the logs to the far left and far right against the sides
of the fi rebox.
Figure 21.2.
5. To clean the logs, use a vacuum cleaner and a soft brush
attachment or a paint brush.
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
NOTE:
Due to the abrasive nature of a pellet appliance fi re, the
logs are not covered under warranty. Any placement vari-
ation other than shown here can cause excessive heat and
shall void the appliance warranty.