R
December 1, 2011
Page 19
Santa Fe NZ Pellet Stove
7068-114B
D. Igniter Replacement
Thumb Screw
Igniter
Firepot
Figure 19.1
1. Shut down the appliance by turning down the thermostat
and let the appliance completely cool down
.
After the
appliance has cooled down, unplug it and remove the
ash drawer.
2. The wire leads to the igniter are connected to the wire
harness with 1/4 inch male / female spade connectors.
Disconnect the spade connections and remove the
igniter from the chamber. Loosen thumb screw and
slide igniter out.
3. Install new igniter into the chamber and tighten thumb
screw. Re-connect the wires to the 2 leads with the
spade connectors.
4. Double check that the igniter wires are clear of any
movement, i.e. ash drawer, firepot cleaning rod,
cleaning slide plates, etc.
5. Re-install the ash drawer and side panel and re-connect
the power.
E. Baffle & Brick Set Removal
1. Follow proper shutdown procedures in Section 10.
2. The top baffle has a hook on the bottom left side that
rests on the top lip of the cast brick. There is a tab on
the bottom right side that hooks into the side bracket.
Remove the top baffle by first pulling the baffle forward
until back edge drops down. Then slide baffle back until
the front edge clears the shelf that it had been resting on.
Figure 19.2.
3. The top baffle must be removed before you can remove
the right and left brick. Remove the right brick by hold
-
ing top lip of brick and lifting up, then push outside edge
back. Slide brick to the right until it is flush with the firebox.
Rotate the inside edge of the brick forward and remove
brick. Repeat for left brick.
Figure 19.3.
Hook on
left side
Tab on
right side
Remove Right
& Left Brick
Vacuum
Exhaust Area
Right Brick
Removed
Figure 19.2
Figure 19.3
Figure 19.4