R
December 1, 2011
Page 17
Santa Fe NZ Pellet Stove
7068-114B
NOTE: Any warranty on the fire or its parts is void if damage
is caused during maintenance, or if maintenance is done
incorrectly.
Replacement Parts
4
A. Convection Blower Replacement
1. Turn down the thermostat, let appliance completely cool
and then unplug appliance before servicing.
2. The Convection Blower is located on the floor at the
rear of the appliance.
3. Remove the right side curtain by loosening 7/16” nut in
th back and lift off of the appliance. When re-installing
flex curtain to re-attach.
Figure 17.1.
4. Cut the tie wire holding the wires together and then dis
-
connect the red and black wires.
5. Remove wingnut and hold-down bracket and then
remove blower.
6. Re-install in reverse order.
7. Attach new tie wire to hold wires together.
Back of Side Curtain
Slot
Ribs on Curtain Slide into
Slots at Top and Bottom
Figure 17.1
Figure 17.2
B. Combustion Blower Replacement
1. Turn down the thermostat, let appliance completely cool
and then unplug appliance before servicing.
2. Remove both side curtains.
Figure 17.1. .
3. Disconnect the red and black wires from the white and
blue wires from the exhaust blower.
4. There is a removable plate on the exhaust blower. Using
a 1/4” socket or short standard screwdriver loosen the 6
screws in the keyhole shaped holes and rotate the plate.
Figure 17.4.
5. Remove the exhaust blower and gasket.
6. Re-install in reverse order.
Side curtains slip under the 6 nuts
identified by the square marking.
Remove the circled screws to
remove the upper and lower rear
screens.
Figure 17.3
Figure 17.4
