Page 20
7050-128G
May 12, 2014
Santa Fe Pellet Stove
R
3 to 3 inch Top Vent Adapter
3 to 6 inch Top Vent Offset Adapter
1.
Put a layer of high temperature silicone on the 3
inch (76mm) exhaust outlet.
Do not put silicone
inside of pipe. Figure 20.1
2.
Slide the top vent adapter onto the rear exhaust
outlet and adjust the assembly to a vertical position.
Figure 20.1.
3.
Drill 4 holes with #26 drill bit (provided) into the back
of the appliance using the outer shield as a pattern
(make sure the assembly is vertical).
Figure 20.2.
4.
Install the 4 mounting screws.
5. Drill 2 holes with #26 drill bit through the rear
exhaust outlet using the 2 holes already in the short
horizontal pipe in the top vent adapter as a guide.
Install the 2 screws.
Figure 20.1.
6.
Install the vent pipe into the top vent adapter (be
sure to silicone all joints).
7.
To clean the top vent adapter open the clean-out
cover.
Figure 20.2.
B. Top Vent Adapter Installation
Silicone Rear
Exhaust Outlet
3 to 6 inch
Offset Adapter
Use Hole on Each
Side as Drilling Guide
3 to 3 inch Top
Vent Adapter
Drill Holes in back of
stove and secure with 4
screws, 2 on each side
Clean-Out Cover
Figure 20.2
Figure 20.1
Installing the Top Vent Adapter
C. Rear Vent and Rear Vent to Top Vent
Adapter Installation
Clean-Out Cover
Clean-Out Cover
Figure 20.3 - Rear Vent Adapter
Figure 20.4 - Rear to Top Vent Adapter - 90
o
1.
Put a layer of high temperature silicone on the 3 inch
(76mm) exhaust outlet.
Do not put silicone inside of
pipe. Figure 20.1.
2.
Slide the adapter onto the rear exhaust outlet and adjust
the assembly to the appropriate position.
3.
Install the vent pipe into the adapter (be sure to silicone
all joints).