Quadra-Fire • QV36DB-A • 2018-900 Rev. F • 12/07
30
Figure 41
Replace the grate and logs referring to the log instructions.
Position the right wall all the way to back wall. Secure in
position same as was done for the left wall (see Figure 42).
Figure 42
Installing the Trim
Combustible materials may be brought up to the specified
clearances on the side and top front edges of the fireplace,
but
MUST NEVER
overlap onto the front face. The joints
between the finished wall and the fireplace top and sides
can only be sealed with a 300° F. (149° C) minimum sealant.
WARNING: WHEN FINISHING THE FIREPLACE,
NEVER OBSTRUCT OR MODIFY THE AIR INLET/
OUTLET GRILLES IN ANY MANNER.
Install optional marble and brass trim surround kits as
desired. Marble, brass, brick, tile, or other non-combustible
materials can be used to cover up the gap between the
sheet rock and the fireplace.
Do not obstruct or modify the air inlet/outlet grilles. When
overlapping on both sides, leave enough space so that the
bottom grille can be lowered and the trim door removed.
!
Step 10. Installing Trim, Refractory, Logs,
and Ember Material
Figure 38
Refractory Kit Placement (BRICK-292)
CAUTION: REFRACTORY IS FRAGILE! CAREFULLY RE-
MOVE THE REFRACTORY FROM THE PACKAGING.
Remove the logs and log grate from the fireplace. Place the
back wall refractory centered against the back of the fire-
place on the back refractory ledge (see Figure 38).
When positioning the left wall use care in not knocking the
back wall down. Position the left wall all the way back against
the back wall. Using the retaining clip and screw included,
secure the side wall refractory as shown (see Figures 39
and 40).
Figure 39
Figure 40
