44
Quadra-Fire • EXCURSION-I, EXCURSION-II, EXCURSION-III Installation Manual • 2538-980 Rev. E • 5/19
Figure 19. Log #4 Installed
Figure 20. Log #5 Installed
LOG #4:
Place the left tip of Log #4 against pin A and lay flat on the burner. Rotate the log forward until it contacts both pin
B and pin D. Log will contact all 3 pins. See Figure 19.
5
3
Figure 18. Log #3 Installed
2
4
3
LOG #3:
Place lower right side of Log #3 against pin F and burnout end of Log #3 on flat spot of Log #2. Slide the burnout
end of log back until it contacts the back refractory. The back of right side of log will contact the right side refractory. See
Figure 18.
F
A
B
D
LOG #5:
Place the burnout tip of Log #5 against pin C and the end of grate tine. Place the bark end on the flat spot of Log
#3. See Figure 20.
C
Figure 16. Log #1 Installed
Figure 17. Log #2 Installed
LOG #2:
Place the bottom right end of Log #2 against pin E and the left end of the log on the flat spot of Log #1. Back side
of log will be pushed up against the air scoop. See Figure 17.
AIR SCOOP
1
1
2
E