R
R
R
April 9, 2009
7051-158
Page 1
EDGE 60 Pellet Fireplace
B. Wall Control Error Codes
Error Message
Possible Cause
Corrective Action
SNAP DISC TRIPPED
Overheat sensor (snap disc) has tripped
Convection blower may need cleaning
Turn power off to appliance and manually reset snap
disc then turn back on. If that doesn’t work, call your
dealer.
Clean convection blower if needed.
AUGER JAMMED
Auger jammed, feed motor bad
Use clean-out tool to clear jam.
Empty hopper and look for foreign objects and
remove
Turn the power switch OFF and then back ON to
clear error code
MISSED IGNITION
Out of fuel or fuel has clumped together to form
a dam in hopper
Break up pellets that have clumped together
Refill hopper if fuel level is low
MIN FIREPOT TEMP
Out of fuel
Refill hopper
Add handful of pellets to firepot
MAX DROP TUBE TEMP
Wrong fuel table setting
Flame height set too high
Components may need cleaning
Confirm setting matches burning fuel
Adjust flame height
Clean the firebox, heat exhanger, convection blower,
firepot and ash pan. If problem persists, call your
dealer.
CHECK ASHPAN
Auto-clean jammed
Turn the power switch OFF and then back ON to
clear error code.
If ash pan is empty, check for a jam. Use the clean-
out tool and firmly push in the firepot floor holes and
flex spring and push toward home to release jam. If
problem persists, call your dealer.
SCREEN GOES BLANK
Static discharge or nearby lightening or Electric
Fast Transients at the input mains
Wait 5 seconds and press any key. If the screen
does not come back on, call your dealer.
Hopper lid not closed all the way.
Close the lid. If that didn’t work the switch is out,
call your dealer.
Firebox door is not latched properly
Fireplace may not be rolled in completely
Check the latch, if OK the door switch may be out,
call your dealer.
If fireplace is completely rolled in, interlock switch
may be out, call your dealer.
Out of fuel
Check fuel level, if OK the switch may be out, call
your dealer.
