Quadra-Fire • Adventure-III Installation Manual • 4083-901 • Rev B • 05/15
20
C. Fan (Optional)
1. This appliance is designed to accept the optional BK-350
fan kit.
2. The fan is designed to automatically increase and
decrease its speed based on the temperature inside the
appliance.
3. To install the fan kit ensure the appliance is not hot and
the fire is completely out.
4. Unplug your appliance from the wall.
5. Locate the square plate on the back center of the appli-
ance.
6. Remove the 4 Phillips head screws securing the plate to
the appliance and keep the screws.
7. Remove plate and discard.
8. Install the fan in the opening with the fan wire hanging in
the 6 o’clock position.
9. Secure the fan with the 4 scews used to hold the plate in
place.
Shock Risk
.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded 3 prong
receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front of appliance.
CAUTION
Figure 5.6
Discard if optional fan installed
Fan (optional)
Thermostat
Terminal Block
Pedestal Screen
(remove for optional
Outside Air Kit)
Power Cord Connection
Fan Connection
10. Plug the fan cord into receptacle located on the bottom
back left hand side of the pedestal.
11. To install the fan speed control open the control access
door on the pedestal and remove Control Board Cover.
12. Remove the 2 screws on the inside front left edge to
remove the fan speed control plate.
See Figure 5.8.
13. Once the plate is removed take the fan speed control,
remove the locknut from the shaft, install the fan speed
control through the hole. Notice the locating pin on the
speed control should align with the small hole in the
face plate. Place the locknut on the speed control and
tighten.
14. Run the wires through the channel and connect to the
corresponding pin locations on control board on the left
side.
Fan Speed Control
Control Board
Cover
Screw
Screw
Figure 5.7
15. Reinstall the fan speed control plate to the bottom of the
appliance.
16. Replace the control board cover.
17. Place the dial control knob on the shaft of the fan speed
control.
18. Turning the dial control clockwise will increase your fan
speed setting.
19. To turn the fan off turn the dial control counterclockwise
to the off position.
Fan Speed Control
Figure 5.8
