17
September 9, 2019
7033-350E
31M-ACC-C
B. Door Handle Assembly
Figure 17.1
Install spring handle using a counter-clockwise motion until
the spring handle has a 2 inch clearance from bend of door
hand rod
(Figure 17.1).
1. Locate bolts supplied with the blower.
2.
Align holes in mounting flange of blower with bolt holes
in appliance. Blower should be positioned at bottom of
rear outer skin as shown in Figure 17.2
3. Re-insert and tighten bolts, securing blower onto outer
wall of appliance.
4. Place the bracket containing the snap disc and magnet
under the bottom left rear corner.
See Owner’s Manual for detailed operating instructions for
the blower and snap disc.
Figure 17.2
MANUAL:
Over-rides
the Snap
Disc
AUTO: Fan
will turn
ON/OFF
Automatically
by the Snap
Disc
Controls
the Fan
Speed
Snap Disc
Bracket
with Magnet
MANUAL
FAN
AUTO
LOW
HIGH
OFF
Secure wires
with wire tie
Secure blower
with 3 bolts
C. Blower (Optional)
Door Handle
Spring
Handle
2 inch (51mm) clearance
required from bend in door
handle rod to end of spring
handle.
Shock Risk
.
• Do NOT remove grounding prong
from plug.
• Route cord away from appliance.
• Do NOT route cord under or in front
of appliance.
• Plug directly into properly grounded 3
prong receptacle.
CAUTION
