22
02/23
7039-802G
Figure 22.2
D. Door Handle Assembly
Service Part: SRV7039-008
1. Install washer on door handle shaft.
2.
Slide door handle through door.
3.
Install second washer(s) as shown in
Figure 22.2
.
4.
Install key in groove.
5.
Align groove in latch cam with key; slide latch cam
over shaft
6.
Install locknut but do not over tighten, the handle needs
to move smoothly.
7.
Install spring handle turning in a counter-clockwise
motion to required 2 inch (51mm) clearance location on
door handle rod
(Figure 22.2)
.
Magnet
Spade
Connectors
Snap Disc
Figure 22.1
C. Snap Disc
Service Part: SRV230-0470
1.
Locate the snap disc bracket assembly at the bottom left
rear corner of the appliance.
2.
A magnet holds the bracket to the appliance. Pull the
bracket down away from the appliance to expose the
snap disc.
3. Pull the snap disc and spade connectors up and out of
bracket as shown in
Figure 22.1
4.
Using a Phillips head screw driver, remove the 2 screws
from the snap disc and then remove the snap disc from
the spade connectors. Replace with new snap disc and
re-connect to spade connectors.
5.
Push the snap disc and spade connectors back inside
bracket and re-attach the bracket to the appliance.
Locknut
Door Cross
Section
Latch Cam
Spacing
Washers
Square Key
Door Handle
Shaft
Spring
Handle
NOTE:
DO NOT over tighten locking nut; door handle
needs to move smoothly!
