6
MULTI-SHEET FEEDING (OPTIONAL)
The multi-sheet feeder is designed to fold pre-collated stapled or unstapled sets of up to four 20 # (75gsm) sheets of
paper.
NOTE:
This feature will not work in AutoBatch mode. The home screen must be displayed in order for the multi-
sheet feeder to work properly.
1. Adjust the side guides on the multi-sheet feeder for the
correct paper size. Loosen the thumb screw, adjust the
guides to fit the paper width and re-tighten the thumb
-
screw (Fig 9a).
2. Slide the pre-collated paper set into the multi-sheet
feeder. When feeding stapled sets, the documents
should be placed with the staple on the operator’s side
and leading (Fig 9b).
3. The paper stack will be automatically pulled into the
folder.
4. If the fold is skewed, turn the skew adjustment knob
located on the back of the feeder left or right to make
corrections (Fig 9c).
5. To remove the multi-sheet feeder, squeeze the release
levers located on either side of the lower back side of
the feeder (Fig. 9d), tilt the feeder forward and lift. To
reinstall, squeeze the levers and reinsert.
Staple
Fig. 9b
Fig. 9a
Fig 9c
Brass thumbscrew
Skew Adjuster
Release Levers
Fig. 9d