REMOVING INFEED TIRES
The infeed tires can easily be removed for cleaning and
replacement. Remove the Allen screw located on the left
side of the feed tire shaft (Fig. 14a). Slide the shaft to
the right to release from the side frame and remove (Fig.
14b).
Allen Screw
Fig. 14a
Fig. 14b
9
OPERATOR MAINTENANCE
1. I
t is recommended to let forms cool for one-half hour, from the laser printer, before folding. This allows toner to set
on the forms and static electricity to discharge. A Jogger is recommended for best results. The Jogger squares the
forms and dissipates heat and static electricity created by laser printers.
2. Clean in-feed tires and fold rollers with recommended roller cleaner & rejuvenator to remove paper dust and toner. A
Cleaner Kit is available from your dealer. A damp cloth with water is the best alternative.
CAUTION:
Do not use any chemicals other than the roller cleaner & rejuvenator or water.
Fig. 15
Fold Rollers
1. Make sure machine is turned off and unplugged. All folders
have four (4) rubber rollers (Fig. 15).
2. Remove the upper and lower fold plates.
3. Using roller cleaner, spray a new cotton cloth until the cloth
is saturated. Wipe the wet cloth in a back and forth motion
making sure to clean the entire surface of the fold rollers.
Next use a dry cloth and wipe off excess toner. The cloth
should be covered with black toner surplus from cleaning the
rollers.
4. Run 10-15 sheets of blank copy paper through the folder to
ensure all cleaner has been removed from the fold rollers.
Running blank sheets will remove any excess residue of
cleaner on the rollers.
CLEANING PROCEDURES:
