AT&S0=1
---- Set Modem as answer
ATE0 ---- Not display the input characters
ATQ1 ---- Commit instruction and not display
AT&W&W1 ---- Save parameters
Step 5: Use DCE cable to connect Modem with DVR RS232 port.
Setup at PC end
Step 1: Setup Modem used on PC side.
Use DCE cable to connect
Modem with PC serial port. You can use HyperTerminal or NetTerm to
setup modem:
AT&F ---- Restore default parameters (Generally, Modem is hard flow
control)
AT&W&W1 ---- Save parameters
Step 2:
Open “Network and Dial-up Connections” in control panel,
then press “New Connection…”, select “Dial-up to private network”
according to the guide. Select the corresponding MODEM, input the
telephone no. to be dialed in the next step, finish it according to the
guide. At this time, you will find a new program named “Dial-up
Connection” in “Network and Dial-up Connections” folder.
Setup should be specially pay attention to:
Open the properties of the new-established dialup program, select
“Advanced”(custom settings) in security option, press setup, set it in
the popup dialogue box that is “Advanced Security Settings” as
follows:
Summary of Contents for QT-500 Series
Page 92: ......
Page 101: ......
Page 115: ...firmware file are setup and run correctly After upgrade finished press any key to reboot DVR...
