160.444UK User Manual
Introduction
Thank you for choosing the LOFOG-400 low level fog machine as part of your stage effects setup.
This machine is designed to emulate low lying dry ice effects using cooled fog fluid.
Please read and keep this manual to ensure maximum performance and avoid damage through misuse.
Unpacking
Your LOFOG-400 should reach you in good condition and should be supplied with IEC mains lead(s) and a
wired handheld remote control. If there are any signs of damage or items missing from the packaging, contact
your dealer immediately.
Warning
To prevent risk of fire or electric shock, do not expose electrical parts to rain or moisture.
If liquids are spilled on the housing or through the vents, disconnect the mains, allow the LOFOG-400 to dry
out and have it checked by qualified personnel before further use.
Avoid any impact, dropping or extreme pressure to the housing.
No user serviceable parts inside - do not open the case (other than to access the ice reservoir)
Refer all servicing to qualified service personnel.
Placement
The LOFOG-400 has an ice reservoir and fluid tank, so should be operated in the upright position only.
Choose a position where the fog output nozzle is not obstructed and is facing the general area to be filled.
Ensure easy access to the rear panel, fluid tank and ice reservoir
Safety
Check for correct mains voltage and condition of IEC lead before connecting to power outlet
Check the condition of the remote lead and ensure that it is not trapped
This unit must be earthed
Cleaning
Use a soft dry or slightly damp cloth to clean the casing
Do not use strong solvents for cleaning the unit
It is recommended to use fog machine cleaning fluid (160.670UK) periodically
Setting up
The LOFOG-400 requires fog fluid and ice (water ice) to produce the effect.
It is recommended to use qtx low level fog fluid for best results (160.592UK, 160.593UK)
This fluid is specially formulated to achieve a dense, low lying fog effect.
A chart for recommended fog fluids is included.
Unscrew the top cap of the tank and fill with the recommended smoke fluid.
Screw the cap securely ensuring the pipe is fed down to the bottom of the bottle so a consistent flow of fluid
is supplied to the machine.
Unscrew the safety screw on top panel to open and fill the reservoir with no more than 2kg of ice.
Close the top panel and secure the safety screw.
Connect the remote control via the REMOTE connector on the rear panel.
Connect the IEC mains plug, ensuring correct supply voltage.
