QTECH
Software Configuration Manual
22-243
reply from 001f : ce10 : 14f1
5 packets transmitted, 5 packets received, 0.0% packet loss
22.4.9
cfm traceroute
cfm traceroute command is used for link tracert and checking network connection. Configure it in global
configuration mode :
cfm traceroute
[
-f
first_ttl
|
-h
maximum_hops
|
-w
time_out
] target-
mac
level
level-id
vlan
vlan-id
Parameter :
first_ttl : first ttl of sending
packet which
is in the range of 1 to 255 and default value is 255;
maximum_hops : max ttl of sending packet which is in the range of 1 to 255 and default value is 10;
time_out : the response timeout after sending packet which is in the range of 10 to 60 with the unit of second
and default value is 5 seconds;
target_mac : destination mac address
level-id :
the integrity from 0-7
vlan-id : VLAN to be tracerted
For example :
! cfm traceroute 00 : 1f : ce : 10 : 14 : f1 level 4 vlan 110
QTECH#cfm traceroute 00 : 1f : ce : 10 : 14 : f1 level 4 vlan 110
22.4.10
Display cfm domain
Configure it in any configuration mode :
It will display as following :
·
cfm domain name
·
cfm domain level
show cfm domain
For example :
! Display cfm domain
QTECH(config)#show cfm domain
22.4.11
Display cfm maintenance-points local
Configure it in any configuration mode :
It will display as following :
§
cfm maintenance-points mpid
§
cfm maintenance-points type
§
cfm maintenance-points vlan
§
cfm maintenance-points level
§
cfm maintenance-points interface
§
Enable/disable cfm maintenance-points
§
cfm maintenance-points mac address
show cfm maintenance-points local
