2
TD-001570-01-A
Yoke Mounting the CP Series Loudspeakers
WARNRNG!:
Read and follow these instructions carefully. If the loudspeakers are not installed
properly, they could fall, causing personal injury or death, and damage to the equipment.
Rules for Mounting
• Consult a Professional Mechanical or Structural Engineer, licensed in the jurisdiction of the
sound system installation, to review, verify, and approve all attachments to the building
or structure.
• Employ the services of a Professional Rigger for hoisting, positioning, and attaching the
equipment to the supporting structure.
• Correct use of all mounting hardware and components is imperative in sound system
installation and deployment.
• Consult local codes and regulations to fully understand the requirements for installed loads in the venue in which you will install the equipment.
• Use only the recommended yoke for installing the loudspeaker.
• Be absolutely certain of the integrity of any structural member intended to support the loudspeaker(s). Hidden structural members can have
hidden structural weakness.
• Never assume anything! Owner or third-party supplied attachment points may not be adequate for installing the loudspeakers.
• Before lifting, always inspect all components (enclosures, brackets, pins, frames, bolts, nuts, etc.) for cracks, wear, deformation, corrosion,
missing, loose, or damaged parts that could reduce the strength of the assembly. Discard any worn, defective, or suspect parts and replace
them with new appropriately load-rated parts.
Yoke Mounting
Each model has two yoke-mounting points, one on each end of the enclosure.
Yoke Installation Options
Vertical and horizontal are the basic options; there are many possible positions based on the requirements of the venue. Make sure that the surface
is appropriate for the size of the yoke, the weight of both the yoke and loudspeaker, and that the appropriate attaching hardware is used.
Prepare the Yoke
Refer to Figure 1.
1. Remove the protective paper from the back of a mounting pad (1).
2. Align the slot in the pad with the slot in the yoke (2) and press the
adhesive side of the pad against the inside of the yoke.
3. Repeat for the other mounting pad.
RNOT!:
The loudspeaker can be secured to the yoke
using the two button-head screws or, the supplied knobs. The
button-head hex screws give you greater security (requires a
tool to remove) or you can use the knobs for ease of removal.
The two threaded inserts (4) are used for storage of the
knobs or screws.
Model
Weight (kg)
Weight (lbs)
CP8
9.5
21.0
CP12
13.7
30.3
Figure 1
1
1
2
3
4
4
