6
Wire the Loudspeakers
1. Back out the conduit cover's Phillips retaining screw to its stop point and pull the conduit cover straight out to remove as shown in step 1 of Figure 4.
2. Pass the CAT cable through the conduit/stress-relief clamp, leaving enough wire for making connections as shown in step 2 of Figure 4. Carefully tighten the clamp over the wires, or over the
conduit if used.
3. Plug the RJ45 connector securely into the jack as shown in step 3 of Figure 4.
4. Reattach the conduit cover and secure with the Phillips retaining screw as shown in step 4 of Figure 4.
1
2
3
4
— Figure 4 —
RJ45 CONNECTOR
RETAINING SCREW
CONDUIT COVER
RETAINING SCREW
CONDUIT COVER
CONDUIT COVER
CONDUIT CLAMP
CONDUIT
CONDUIT COVER
CAT CABLE
