QSC AF3082-L, User Manual

Page: 8 / 100

EN
8
Suspending the WideLine-8 Array
Suspending the WL212-sw beneath AF3082-S or AF3082-L
All orientation of product is to be viewed from the rear of the enclosure. The QSC logo on
the input plate will appear right side up when the enclosure is oriented properly.
1. Lower the array frame onto the subwoofer and align the appropriate holes in the suspen-
sion links and frame, fully insert the ball-lock pins, and ensure all pins lock properly. On
the array frame, use the center hole to attach the sub’s rear link (labeled 0°).
2. Attach the AF3082-S or AF3082-L array frame to the suspension structure using 5/8"
(16mm) screw-pin anchor shackle and appropriate sling, cable, etc.
Note! The +5° and -5° positions can not be used when suspending the sub-
woofer from the array frame.
3. Before lifting, ensure the audio connection to the enclosures are correct and functioning.
NOTE: When arraying two or more WL212-sw subwoofers with one person,
it is easiest to lay the enclosures on their backs, align and mate the sus-
pension straps, and install the ball-lock pins. When installing the ball-lock
pins, ensure full insertion and locking action.
Figure 17: WL3082 enclosures suspended
below WL212-sw with AF3082-S array frame.
Figure 15: WL212-sw attached to AF3082-S.
Figure 16: WL212-sw suspended beneath AF3082-L
Suspending WL3082 enclosures beneath WL212-sw enclosures
1. For arrays of 4 WL3082 or less, pin together the cluster of enclosures or prepare pre-
pinned array from transport cart. When constructing large arrays it is recommended to
first assemble units of four enclosures and then assemble the final array by joining the
four enclosure units to one another. Note the QSC logo on the input plate will be right
side up when the enclosure is oriented properly). During assembly, ensure your splay
angles are set as desired.
2. Lower the array frame with subwoofer(s) onto the WL3082 enclosure cluster, carefully
aligning the appropriate holes in the suspension plates and links. Attach the top enclo-
sure to subwoofer by inserting the ball-lock pins, and ensuring all pins lock properly.
Ensure selection of the desired splay angle on the rear links (0°, +5°, -5°).
3. Before lifting, ensure the audio connection to the enclosures are correct and functioning.