QSC AD-S282H, User Manual

Page: 7 / 16

7
Connection
I-282H
PASSIVE: Set the BI-AMP / PASSIVE selector switch to PASSIVE . Con-
nect the full-range + input signal to Speakon pin 1+ and the full range -
input signal to Speakon pin 1-. The two Speakon connectors wired in paral-
lel, allowing a second I-282H loudspeaker (also set for
PASSIVE operation)
to be connected directly to the remaining Speakon connector.
ACTIVE: Set the BI-AMP / PASSIVE selector switch to BI-AMP. Con-
nect the low fre signal to Speakon pin 1+ and the low frequency -
signal to Speakon pin 1-. Connect the high fre signal to Speakon
pin 2+ and the high frequency - signal to Speakon pin 2-. A second I-282H
loudspeaker (also set for
BI-AMP operation) may be connected in parallel
by connecting it to the remaining Speakon connector using a four wire
Speakon connection.
AD-S282H
PASSIVE: Set the BI-AMP / PASSIVE selector switch to PASSIVE .
Connect the input to the PASSIVE
+
and PASSIVE
-
terminals on the rear
of the loudspeaker. Do not use second set of terminals marked HF
+
and
HF
-
.
BI-AMP: Set the BI-AMP / PASSIVE selector switch to BI-AMP. Con-
nect the low frequency signal to the terminals marked LF
+
and LF
-
. Con-
nect the high frequency signal to the terminals marked HF
+
and HF
-
.
AD-S282HT
Connect the input to one set of the
+
and
-
terminals on the rear of the
loudspeaker.
Additional loudspeakers may be connect to the second set of
+
and
-
ter-
minals.
I-282H
Speakon
pinout
Speakon plug
pinout as viewed
from wire-side
AD-S282H
terminal
pinout
AD-S282HT
terminal
pinout