44
©
Copyright 2017 QSAN Technology, Inc. All Right Reserved.
8.
Buzzer Indicator Table
Number
Beep Sound
No. of Times
Description
1
Short beep
(0.5 sec)
1
The XCubeNAS is ready (finish start up).
The XCubeNAS is being shut down
(software shutdown).
The system firmware has been updated.
USB drive is removed
The user starts hard drive rebuilding.
2
Long beep
(1.5 sec)
Beep until
event
finishes,
interval of 0.5
sec
1) The system pool has reached its full
capacity (100%). 2) The system pool is
going to be full (95%). 3) The system fan
is out of function. 4) A bad sector is
detected on the hard disk drive or hard
disk failed. 5) One of the pool is in
degraded mode. 6) Hardware self-test
error.
e.g.
PSU failed, abnormal voltage,
the temperature is at critical high/low,
any cooling fan module failed or
removed, any pool failed. 7) Remove hard
disk or solid state drive.
Not
e: If one event has triggered the beep sound, the next event will not trigger the beep
sound until the previous event has finished.
Note 2:
The beep sound will not be triggered if buzzer function is disabled from the QSM.
You can check the error messages through the
Notification Center
on QSM.
