Step 2: Prepare the Collar Receiver
1.
Follow the Positive (+) and Negative (-) signs inside of receiver. Insert the 1 x 6V
4LR44 Battery for each Receiver.
2.
The
Red Indicated Light
will stay on for 2 second and start blinking.
3.
Press the
Vibration Button
(in the middle of the transmitter).
The Receiver will
vibrate for both Receivers at the same time
.
Note:
Please always install the transmitter’s battery BEFORE install the battery of
receiver. As it is a wireless training system. The transmitter has to be power on
then the receivers are able to receive the code from transmitter.
Step 3: Install the Electrodes for the Receiver.
Randomly pick one pair of electrodes and
screw for receiver. (Please pick the same
size electrodes for the receiver.)
Step 4: Adjust the collar to fit your pet.
To ensure a proper fit, please follow the steps below:
1.
Put the strap on the receiver.
2.
With your pet standing, center of collar receiver where contact points are
underneath your pet’s neck, touching the skin.
3.
The collar receiver should fit snugly, yet loose enough to allow one finger to fit
between the strap and your pet’s neck. If the strap is too long for your pet, cut
off the excess length.
4.
Allow your pet to wear the collar for several minutes and then re-check the fit.
Check the fit again as your pet becomes more comfortable wearing the collar
receiver.
We recommend you to use the vibration function first before starting the static shock
and always start from the lowest level of static shock.
3
