Installing Expansion Cards
A 10GBASE-T network expansion card is pre-installed in the PCIe slot. You can replace it with another
supported PCIe expansion card.
QNAP-branded expansion cards purchased from the company website are shipped with the brackets
necessary to fit all QNAP NAS models. All TS-x63XU models use low-profile brackets.
Warning
• Only qualified personnel should perform the following steps. Failure to follow
instructions can result in serious injury or death.
• Observe electrostatic discharge (ESD) procedures to avoid damage to components.
1.
Check the expansion cards and brackets supported by your model on the QNAP website.
a.
Go to
.
b.
Click
Search by NAS
.
c.
Specify the number of bays and the specific model of your NAS.
d.
Under
Category
, select the component or device type.
e.
Locate a specific component or device model in the list.
f.
Optional: Click the corresponding
Note
icon to view more information.
2.
Power off the NAS.
3.
Disconnect the power cord from the electrical outlet.
4.
Disconnect all cables and external attachments.
5.
Remove the top cover.
a.
Loosen the two screws on the back of the top cover.
TS-x63XU User Guide
Installation and Configuration
17
