QModeling XP Series, Instruction Manual

Page: 3 / 27

r
Long Cotton Swab Sticks (not Q-Tips)
r
CA Glue (i.e., ZAP)
r
Wood Glue
r Sandpaper, 220-400 grit
r
Sanding Block
r
Sanding Sealer
r
Gloss White Enamel Spray Paint
r
Gloss Gray Enamel Spray Paint
r Gloss Black Enamel Spray Paint
r
White or Light Gray Primer Spray Paint
r
Brain
r
Scissors
r
Hobby Knife
r Pencil
r
Ruler
r
Paint Brush
Unpack your XP-RAPTOR and check to make sure all parts are
accounted for. If parts are missing contact QModeling by
sending an e-mail to tpquinn@qmodeling.com. The (#X)
designator indicates how many of a given part there should be,
for example Primary Fins (3X) indicates there should be 3
Primary Fins. Please note any part labeled with a MF designator
is a "Make From" part. This means you will be making the part
from the material supplied, for example the Launch Lugs.
Please note the Parts Ordering form
in your kit. Use this form to order
replacement or additional parts.
Additional Items Needed
Forward
of
Rocket
Main Nose Cone
w/Eyelet
Parachute
w/Shroud Lines
Fin Bulkheads (6X)
FFD Antennas (3X)
Heat Shield
Snap Swivel
Decals
3
Kevlar Ò
Shock Cord
Lower Main Body Tube
Primary Fins (3X)
Rear
of
Rocket
Forward Centering Ring
Engine Mount Tube
Fin Brace (3X)
Support Brace (3X)
Rear Centering Ring
Engine Hook
Hex Rings (4X)
Thrust Rings (2X)
Upper Main Body Tube
Transition C-Ring (3X)
Launch Lug (MF)
Secondary Fins (3X)
Transition Cone Tab
Transition Cone Wrap
(shown formed)
Parachute Compartment
C-Ring
Shock Cord Bumper
TE
ST
C
ON
N.
TE
ST
C
ON
N.
TE
ST
C
ON
N.
XP - C.G . L OA DE D
WE IG HT 4 24 7 L BS .
XP - C.G . L OA DE D
WE IG HT 4 24 7 L BS .