Qlogic OFED+ Host, Software User'S Manual

Page: 207 / 284

IB6054601-00 F Preliminary Using LEDs to Check the State of the
Adapter-1
D
Troubleshooting
This appendix describes some of the tools you can use to diagnose and fix
problems. The following topics are discussed:
 Using LEDs to Check the State of the Adapter
 BIOS Settings
 Kernel and Initialization Issues
 OpenFabrics and InfiniPath Issues
 System Administration Troubleshooting
 Performance Issues
 Open MPI Troubleshooting
Troubleshooting information for hardware installation is found in the QLogic
InfiniBand
®
Adapter Hardware Installation Guide and software installation is found
in the QLogic InfiniBand
®
Fabric Software Installation Guide.
Using LEDs to Check the State of the Adapter
The LEDs function as link and data indicators once the InfiniPath software has
been installed, the driver has been loaded, and the fabric is being actively
managed by a subnet manager.
Table D-1 describes the LED states. The green LED indicates the physical link
signal; the amber LED indicates the link. The green LED normally illuminates first.
The normal state is
Green On , Amber On . The QLE7240 and QLE7280 have an
additional state, as shown in Table D-1 .
Table D-1. LED Link and Data Indicators
LED States Indication
Green OFF
Amber OFF The switch is not powered up. The software is neither
installed nor started. Loss of signal.
Verify that the software is installed and configured with
ipath_control -i
. If correct, check both cable con-
nectors.