3
①
PCD 85
Min.Ø5 CABLE ENTRY
3-Ø6 HOLES
Parts Definition/ Installation/ Light Function Selection
Mounting Hole Specifications/ Xenon Bulb Replacement lnstructions
• remove the flange nuts from bolts and place the product through the mounting surface holes.
• Fasten the flange nuts on the opposite side of the mounting surface until the product is tightened securely.
• •
Please refer to the chart below to use light function
selection switch(
①
) located inside the product.
■
Parts Definition
■
Installation
■
Light Function Selection
Lens(AS)
Reflector
(Heat resistant ABS)
Housing(ABS)
Rubber spacer
Flatwasher
Flange nut
LED
• Machine holes on the mounting surface referring to the
diagram below.
■
Mounting Hole Specifications
■
Xenon Bulb Replacement instructions(S125TS only)
• Default function is set at steady LED. Select the desired function
for your application during installation.
▶
L :
Steady
▶
LF : Flash
• Please wait at least 30 mimutes after turning off the power
before replacing the xenon bulb.
• Please pull out the entire xenon bulb structure
①
to disassemble.
• For xenon bulb assembly, please ensure the connector portion
of the xenon bulb structure matches the pin location
②.
①
②
Installation Environment and Protection Rating
•
This product is designed for use with protection rating of IP44.
•
If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating
indicated(IP44), it may cause malfunction or damage to the product.
• In case of outdoor applications, install the product in the upright position. Do not install the product horizontal or upside-
down positions where water can potentially penetrate into the product and impact it’s operation.
•
For further information, please visit our website (www.qlight.com).
Disassemble
bulb
Assemble
bulb
