Qlight QWCD35T, Manual

Page: 5 / 12

5
Body(PC+ABS) Body(PC+ABS)
PCB
Horn(PC)
Resonator(PC) Resonator(PC)
PCB
Horn(PC)
QWCD50T QWCD50TSD
- SD cards are sold separately
SD card
Installation Environment and Degree of Protection
• This product is designed for indoor and outdoor use with protection rating of IP66.
• If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection ratings
indicated(IP66), it may cause malfunction or damage to the product.
• After installing the cable, tighten the cable entry as same level of protection rating of the product and seal it so that dust and moisture
can not penetrate into the product.
• For further information, please visit our website (www.qlight.com).
■
Installation
2-Ø9 HOELS or
2-M8 TAPS
PCD 150-16
3
2-Ø9 HOELS or
2-M8 TAPS
PCD 186-20
2
• First, make taps or holes that match the product
mounting bolts locations on the mounting surface
①
.
• The mounting hole of this product is 9mm in
diameter(long hole).
• If the tap is machined, fasten the bolt through the
mounting hole of the product.
• When machining a hole, insert the bolt through the
product, insert it into the hole, and tighten the nut
from the opposite side of the mounting surface.
• Install a flat washer and a spring washer to the bolt
if the product can experience severe vibration and
shock.
■
Parts Definition
Parts Definition / Installation
■ Tap Machining
■ Hole Machining
Cable gland
Terminal block Terminal block
Cable gland
SD card slot