Qlight QWCD35T, Manual

Page: 4 / 12

4
2-Ø9 HOELS or
2-M8 TAPS
PCD 150-16
3
2-Ø9 HOELS or
2-M8 TAPS
PCD 186-20
2
QWCD35T QWCD35TSD
Body(PC+ABS) Body(PC+ABS)
PCB
Cable gland
Horn(PC) Horn(PC)
Resonator(PC) Resonator(PC)
Terminal block Terminal block
PCB
Cable gland
SD card slot
■
Parts Definition
Parts Definition / Installation
■
Installation
• First, make taps or holes that match the product
mounting bolts locations on the mounting surface
①
.
• The mounting hole of this product is 9mm in
diameter(long hole).
• If the tap is machined, fasten the bolt through the
mounting hole of the product.
• When machining a hole, insert the bolt through the
product, insert it into the hole, and tighten the nut
from the opposite side of the mounting surface.
• Install a flat washer and a spring washer to the bolt
if the product can experience severe vibration and
shock.
■ Tap Machining
■ Hole Machining
- SD cards are sold separately
SD card