Qilive Q.5303, User Manual

Page: 8 / 70

8
EN
-
Attach a cutting guide
. Select a desired cutting guide. Align the cutting guide and the
cutting blade (1) in the same level as shown in the figure below, then slide the cutting guide
onto the cutting head unti you hear a click.
- Detach a cutting guide . As shown in the figure below, apply some force on the cutting
guide to slide it out of the cutting head.
4.3 Start and operate the appliance
- Turn on the appliance . Press the button to switch on the appliance. The appliance
starts working, and the current battery level is displayed.
- Set the cutting length . Turn the cutting length adjustment knob (3) to one of the positions
marked from “0.8” to “2.0mm” range to adjust the cutting length.
- Select the turbo speed . After turning on the appliance, you can press the button again
to switch to the turbo speed. The indicator lights up. In this mode, the appliance
works in a faster speed.
- Switch off the appliance. Press the button once or more until the appliance stops
working.
4.4 Lock/unlock the control button
1. When the appliance is switched off, press and hold the button (about 4 seconds) until
the icon lights up and flashes, and the locking function is activated. In the locking state,
button operation is invalid.
2. In the locking state, press and hold the button (about 4 seconds) until the appliance is
switched on, and the locking function is deactivated.
5. MAINTENANCE AND CLEANING
- Remove the cutting guide after each use.
- Clean the cutting blade regularly to maintain optimal performance.
- For easier cleaning, the cutting blade can be removed.
- Remove the cutting blade . Turn off the clipper. Press on the end of the cutting blade (as
indicated in the figure below) to unlock the blade, then take the blade out.
- Clean the cutting blade with the cleaning brush to remove excess hair.
- Replace the cutting blade . Insert the cutting blade by aligning the tab and the slot as
indicated by “A” and “B” in the figure below, and turn the cutting length adjustment knob (3)
to the position marked “2.0mm”, then press on the blade until you hear a click.