Pot Handle and Lid may become very
warm during use.
www.qiaerista.com
PAGE 07
BEFORE FIRST USE
Press ‘BREW’ again to start the brewing cycle for
cleaning. A solid light will shine on the edge of
‘BREW’ button.
You will be alerted by 4 consecutive beeping sounds
when the brewing cycle is completed. The Brewer
will then enter Keep Warm mode. Press ‘BREW’ to
end the Keep Warm mode.
NEVER pour water/tea out with the
Lid open. When the Lid is open, the
Spray Cap and the edge of the Infuser
will drip water/tea that may cause
injury due to scalding.
Remove the Pot from the Base by firmly gripping the
Pot Handle. Completely discard the hot water.
Let the Brewer cool down for at least 10 minutes.
Remove the Lid and gently lift up the Infuser by the
Silicone Rubber Rim. Fill the Pot again up to the ‘MAX’
line with clean water and re-attach the Lid and
Infuser on the Pot securely.
After the second brewing cycle is finished, press
‘BREW’ to end the Keep Warm mode. Remove the
Pot from the Base by firmly gripping the Handle.
Completely discard the hot water.
AUTO-CLEANING THE BREWER
TURNING BREWER OFF
With the light at ‘Black’ on, press ‘BREW’ to start the
second brewing cycle.
The Brewer will shut off automatically when no
button is pressed within 15 minutes during standby.
To turn off the Brewer manually, long press ‘BREW’
for 2 seconds until a beep sounds and all lights are
off.
ALWAYS ensure the Lid and the Infuser
are securely attached to the Brewer
during operation and pouring.
DO NOT fill the Pot while hot with
chilled water. Allow the Pot to cool
before refilling.
Filling past the maximum water level
may result in serious burns or injuries
as a result of overflowing hot water.
14
15
16
17
18
19
Let the Brewer cool down for at least 10 minutes.
Remove the Lid and the Infuser and squeeze on the
Spray Cap to release any remaining water in the Flow
Tube.
20
Now, the Brewer is ready to brew tea.
21
22
23