www.qiaerista.com
USAGE GUIDE
PAGE 09
KEEP WARM MODE
HEAT MODE
With Keep Warm mode, the Brewer will maintain at a
preset keep warm temperature of 70
o
C/158
o
F for 60
minutes.
After brewing completes, the Brewer will automati-
cally switch to Keep Warm mode. A slow blinking
light on the edge of ‘HEAT’ on the Base will show.
Note: Keep Warm mode does not apply to Cold Brew.
The Keep Warm mode will continue for the preset
duration of 60 minutes and end with 2 beeps, unless
it is stopped due to any of the following conditions:
To reactivate the Keep Warm mode, long press the
‘HEAT’ Button for 2 seconds until a slow blinking
light appears and a beep sounds.
Remove the Lid and Infuser. Fill the Pot with clean
drinking water within the ‘MAX’ and ‘MIN’ water
levels.
Secure firmly the Lid and Infuser on the top of the
Pot. Ensure the Spray Cap fits comfortably inside the
Infuser.
Place the Pot properly onto the Base, ensure proper
alignment of the Connector and Positioning Pin.
Insert the Plug into a grounded wall socket.
Turn on the Brewer by long pressing ‘BREW’ on the
Base for 2 seconds until a light illuminates and a beep
sounds.
Before starting Keep Warm mode, always
ensure the fluids inside the Pot are within
the 'MAX' and 'MIN' levels.
The Heat mode and Keep Warm mode
share the same button on the Base.
The Pot Handle and Lid may become very
warm during and after the end of the
keep warm or heating cycle.
Press ‘TYPE’ to toggle the desired tea type selection.
A light will shine for the tea type selected.
Press ‘HEAT’ to start heating water.
Note: A solid light will illuminate on the edge of
‘Heat’ button. If instead the light is slowly blinking,
then it has entered Keep Warm mode. Switch back to
Heat mode by pressing ‘Heat’ twice.
The Brewer will beep 3 times when the heating cycle
is completed.
Remove the Pot from the Base and exercise caution
in pouring out the hot water. NEVER open the Lid
and Infuser when pouring and DO NOT put your hand
under the Spout.
To stop the Brewer during the Heat cycle, you can
apply either of the following procedures:
PRESET HEAT MODE PARAMETERS
Teas
Preset Temperature
Black
Green
White
Pu’er
Oolong
Herbal
Custom
Strong
Cold
100
o
C/212
o
F
85
o
C/185
o
F
90
o
C/194
o
F
100
o
C/212
o
F
95
o
C/203
o
F
100
o
C/212
o
F
100
o
C/212
o
F
100
o
C/212
o
F
N/A
a) ‘BREW’ or ‘HEAT’ is pressed on the Base.
b) ‘STOP’ button is pressed on the app.
a) ’BREW’ or ‘HEAT’ is pressed on the base.
b) The ‘STOP’ button is pressed on the app.
The Brewer can function as a smart kettle to heat
water to the preset temperature according to tea
type. This option is optimal for teapot, gaiwan or
mug brewing. Note: Heat mode does not apply for
Cold Brew.
01
02
03
01
02
03
04
05
06
07
08
09
10
