28
– 02|2017 – Subject to change.
Speedkid2
Speedkid2
Subject to change. – 02|2017 –
29
Closing the ventilation window:
f
Release the top Velcro fastener to release the cover.
f
Close the cover with the bottom Velcro fastener.
Danger!
Open
the ventilation window
on hot days or in heavy traffic in order to dissipate warm
air and exhaust fumes out of the cabin more quickly.
Using the panorama roof
The panorama roof has a sun visor and a ventilation window that you can roll up as required or
close with a Velcro fastener.
f
Release the sun visor’s Velcro fastener and roll it up.
f
To improve ventilation in the cabin, you can also roll
up the window film of the panorama roof.
f
Secure each roll with the toggle fasteners.
f
To close, secure the window film and sun visor with
the Velcro fasteners again.
Tip!
To use the sun visor together with the ventilation function, first roll up the window
film and then close the sun visor.
Adjusting the suspension
The suspension of the
Speedkid2
adjusts itself automatically to the load being carried at the
time. They are pre-set at the factory to maximum spring deflection in order to provide maximum
comfort.
If necessary, you can adjust the suspension’s
hardness
individually:
f
Turn the disk above the spring clockwise to make the
suspension harder.
f
Turn the disk anticlockwise to make the suspension
more comfortable.
Danger!
When altering the hardness, it is essential to ensure that you make the same
adjustments on both struts. Different spring deflections can have a negative influence
on riding performance. Alter the factory setting only in exceptional cases.
Storage
To store the
Speedkid2
, simply fold it up and keep it in a protected location. Pay attention also to
the instructions in the chapter
“Care” on page 30
.
Danger!
Hands or fingers can become trapped on moving parts while setting up and folding up
the cab. Carry out work carefully and keep children away from the vehicle.
f
Take position in front of the cabin and open the 2-in-1
canopy.
f
Release the two stabiliser rods at the front by in each
case pulling the tube clamp off the tube of the front
roof support.
f
Fold down both stabiliser rods onto the tube of the
rear roof support.
f
Pull the sliders on the folding system tubes all the way
up in order to release the hinges.
f
Press the upper part of the folding system tubes down
slightly in order to open the hinges.
f
Then press the push handle all the way forward in
order to fold up the cabin.
Caution!
Only fold up the cabin after it has been cleaned both inside and outside and is
completely dry.
Utilisation
Utilisation
