– 2 –
17 .
rEducE ThE rISK oF unInTEnTIonAL
STArTInG.
Make sure switch is in OFF
position before plugging in .
18 .
uSE rEcommEndEd AccESSorIES.
Consult the owner’s manual for
recommended accessories . The use of
improper accessories may increase risk of
injury .
19 .
do noT dry cuT WITh bLAdES
dESIGnEd For WET cuTS.
20 . Make sure you
uSE ThE corrEcT bLAdE
for the type of material that is being cut .
21 .
nEvEr STAnd on TooL.
Serious injury
could occur if the wet saw is tipped or if the
cutting tool is unintentionally contacted .
22 .
chEcK dAmAGEd pArTS.
Before further
use of the tool, damaged part(s), (i .e .,
guard) should be carefully checked to
determine that it will operate properly
and perform its intended function . Check
for alignment of moving parts, binding of
moving parts, breakage of parts, mounting
and any other condition that may affect the
saw’s operation . A guard or other part that
is damaged should be properly repaired
or replaced .
23 . Ensure that
bLAdE IS TrAvELInG
ThrouGh WATEr rESErvoIr For WET
cuTTInG.
24 .
chEcK dIAmond bLAdES
carefully for
cracks, nicks, missing diamond matrix
or out-of-alignment condition . Replace
damaged blades immediately .
do noT
uSE dAmAGEd bLAdES.
They may cause
bodily injury .
25 .
dIrEcTIon oF FEEd.
Feed work into the
blade against the direction of rotation of
the blade only .
26 .
do noT ALTEr ThE pLuG
or use a 2-prong
receptacle . This saw is equipped with a
3-prong electrical plug .
27 .
nEvEr LEAvE SAW runnInG
unATTEndEd.
Turn power off . Don’t leave
tool until it comes to a complete stop .
28 .
poSITIonInG oF TILE SAW
(see FIGURE 1)
FIGurE 1
• To avoid the possibility of the appliance plug
or receptacle getting wet, position the tile
saw to one side of a wall-mounted receptacle
to prevent water from dripping onto the
receptacle or plug . The user should arrange
a “drip loop” in the cord connecting the saw
to a receptacle . The “drip loop” is that part
of the cord below the level of the receptacle,
or connector if an extension cord is used, to
prevent water traveling along the cord and
coming in contact with the receptacle .
• If the plug or receptacle does get wet,
do
noT
unplug the cord . Disconnect the fuse
or circuit breaker that supplies power to the
tool . Then, unplug and examine for presence
of water in the receptacle .
WARNING
PERSONAL INJURY CAN OCCUR IF OPERATED
IMPROPERLY.
• Keep fingers and loose clothing away from
rotating blade .
• Use extreme caution when cutting tile. Make
sure hands and fingers are clear from the
blade groove in the table . Severe abrasion,
cuts, or pinching of hands or fingers can occur.
• Electrical shock can occur if operating
instructions are not followed .
FOR YOUR OWN SAFETY READ INSTRUCTION
MANUAL BEFORE OPERATING SAW.
• Wear eye protection.
• Use blade guard for every operation for
which it can be used .
• Unplug saw before servicing, when changing
cutting wheels, and cleaning .
