35
HOW TO SEARCH THE GROUND
Turn the detector
ON
and
GROUND BALANCE
, then complete the set-up procedure as shown
above.
Lower the detector coil to the ground and move slowly forward, swinging the detector from side to
side parallel but just clear of the ground.
Sweep the coil in a wide arc without lifting the coil at the end of each arc. Overlap each swing over
the previous arc to ensure you do not miss any targets.
When a target is identified swing the coil over the target in one direction, then repeat again at right
angles to confirm target and location. A good target will produce a clear repeatable signal.
Dig out your target and remember to refill your excavation on completion.
Summary of Contents for PL3
Page 56: ...56 NOTES...