QED Environmental Systems
Page 10
ADDP Manual
Chapter 3: Assembly
ASSEMBLY
NOTE: When operating and maintaining the system, disconnect air and
fluid lines cautiously to avoid spilling fluids.
• Wear safety goggles to protect eyes from any splashing or pressure
release.
• Wear chemically resistant rubber gloves when pulling the hoses from
the well to avoid skin contact with the product being recovered.
• The hose which carries the air from the pneumatic circuit to drive the
DDP
is already connected
• Position the system on a level surface. The fluid level should not be more
than 22 feet below the
DDP
.
STEP 1 - LOCKING QUICK CONNECT INSTRUCTIONS
•
Follow the instructions on
Figure 4
for properly securing the locking
quick connects.
STEP 2 - AIR COMPRESSOR to PNEUMATIC SYSTEM -
System Air Supply
Hose
• Connect the FEMALE
air hose socket with 3/8 inch MPT
to the
air compressor making sure to use the teflon tape on the threads.
(See Figure 2)
• Connect the MALE quick connect on the
system air supply hose
to the
FEMALE socket on the air compressor. (See Figure 2)
• A ach the FEMALE quick connect on the
system air supply hose
to
the MALE air supply quick connect near the
air filter
on the pneumatic
system. (See Figure 2)
