Manual for WinneX 5
15
Furthermore in order to implement this function, set “ POWER ON Function” to Password
and set the keyboard power-on password in the “ INTEGRATED PERIPHERALS” section
of the BIOS. Save and exit, then power off your system. In this case, the power
button’ s power-on function has been disabled.
Note:
1. If using this function, 5VSB line of the power supply should be
capable of delivering enough current (eg. 200mA) for all the devices
connected to the keyboard port, if not, you will be unable to power up
the system using the keyboard.
2. If you set JKB with pin2 & pin3 closed, set “POWER ON Function” to
BUTTON ONLY, don’t set it to Password, or you’ll be unable to power up
your system by the keyboard or the power button.
3. If you encounter the above problems, clear CMOS and set the jumper
and BIOS option again.
Overclocking Jumper Setting (JFS0, JFS1)
Jumpers labeled JFS0 and JFS1 are located on the mainboard providing users with CPU
overclocking feature. The host bus speed can be set as 66/100/133MHz or AUTO
select. Refer to the chart below for the location of these jumpers, and the table for
information on how to set them.
chapter 2
JFS0
JFS1
‘ 1-2’ represents pin1 & pin2 closed.
‘ 2-3’ represents pin2 & pin3 closed.
CPU FSB 66MHz 100MHz 133MHz AUTO
JFS0 2-3 OPEN OPEN 1-2
JFS1 1-2 1-2 OPEN 2-3
