© 2005 Directed Electronics—all rights reserved
1
17
7
pprriim
maarryy hhaarrnneessss ((HH11)) wwiirree ccoonnnneeccttiioonn gguuiiddee
When the system receives the code controlling Channel 2, for longer than 1.5 seconds, the red/white wire will
supply an output as long as the transmission continues. This is often used to operate a trunk/hatch release or
other relay-driven function.
IIM
MP
PO
OR
RTTA
AN
NTT!! Never use this wire to drive anything but a relay or a low-current input! The tran-
sistorized output can only supply 200 mA of current. Connecting directly to a solenoid, motor,
or other high-current device will cause it to fail.
Before connecting this wire, remove the supplied fuse. Connect to the battery positive terminal or the constant
12V supply to the ignition switch.
N
NO
OTTEE:: Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 15A
fuse in the harness for this purpose. This fuse protects the module itself.
H
H1
1//2
2 R
REED
D ((+
+))1
12
2V
V cco
on
nssttaan
ntt p
po
ow
weerr iin
np
pu
utt
H
H1
1//1
1 R
REED
D//W
WH
HIITTEE cch
haan
nn
neell 2
2,, 2
20
00
0m
mA
A ((--)) o
ou
uttp
pu
utt
