W
ALL
F
URNACE WITH
P
OWER
F
LUE
Page 3
Introduction
Introduction
Thank you for purchasing this Pyrox product. It has been designed to give you excellent service. Now
it is installed, you are no doubt anxious to run it and enjoy the far-reaching warmth. Before you do,
take a few minutes to read through this instruction booklet and discover how to get the very best from
your heater. After you have read it, we suggest you store these instructions in a safe place for future
reference. If you have any questions of problems relating to your new heater, do not hesitate to get
in touch with your dealer / installer or your nearest Climate Technologies office.
The Australian designed and manufactured Pyrox Gas Wall Furnace has been thoroughly life tested
and carries the Australian Standards gas and electrical approvals.
S
AFE
O
PERATION
1.
Ensure this unit has been installed by a
qualified, licensed gas fitter and that the
240V power point has been installed by a
qualified, licensed electrician.
2.
It is essential to have any existing power
point to which the appliance might be
connected checked by a qualified electrician
to ensure that the power point has the correct
polarity and earthing.
3.
Each Pyrox Gas heater is factory set to
operate on a particular type of gas.
DO NOT
use any type of gas other than that specified
on the appliance and packaging.
4.
Clearances
– See Fig 1.
4.1. DO NOT
drape clothing, towels etc on or
over the heater. Maintain a clearance of
3 metres in front of the heater.
4.2. DO NOT
place articles on or against the
wall furnace
– at least 300 mm
clearance
4.3. DO NOT
cover the outlet louvres of the
wall furnace.
4.4. DO NOT
use or store flammable
materials near the wall furnace
4.5. DO NOT
store or spray aerosols in the
vicinity of the wall furnace while it is
operating.
4.6. DO NOT
use an extension cord with this
appliance.
5.
DO NOT MODIFY THIS APPLIANCE
