Pico-pH-SUB
| Manual
© PyroScience GmbH
24
Example Communication:
Command:
#IDNR
↵
Response:
#IDNR
˽
2296536137892833272
↵
5.4.7
#LOGO
–
Flash Status LED
This command lets the status LED flash for 4 times within ca. 1 s.
Command:
#LOGO
↵
Response:
#LOGO
↵
This command can be used to check proper communication with the device. Or it might
be helpful in setups with more than one device, in order to identify which COM port is
connected to which device.
5.4.8
#PDWN
–
Power Down Sensor Circuits
This command switches off the power supply of the sensor circuits.
Command:
#PDWN
↵
Response:
#PDWN
↵
This command can be used for some power saving during idle operation periods. Note,
that the sensor circuits are automatically powered up again, if the module receives any
command (e.g. MEA) requiring a sensor measurement. This is also the case if a broadcast
measurement takes place.
5.4.9
#PWUP
–
Power Up Sensor Circuits
This command switches on the power supply of the sensor circuits.
Command:
#PWUP
↵
Response:
#PWUP
↵
The wake-up duration is up to 250 ms.
5.4.10
#STOP
–
Enter Deep Sleep Mode
This command puts the device into a deep sleep mode with very low power
consumption
Command:
#STOP
↵
Response:
#STOP
↵
During deep sleep mode the device has very low power consumption. No standard
communication via USB/UART is possible. The deep sleep mode can be only exit by
sending a <CR> (0x0D) to the device. The device will respond then also with a single
<CR> indicating that it is ready to receive new commands. The wake-up duration can be
up to 250 ms.
