Pyronix XD10TTAM, Manual

Page: 6 / 60

Page: 6
XD10TTAM
3. Blocking (via MW)
ON
= Blocking disabled
OFF =Blocking enabled when
system disarmed (see DIP4 /
DIP6 has to be ON)
4. RI 1 mode
ON = RI disabled
OFF = RI enabled
RI is used to enable the Anti-masking and
Blocking feature when DIP2 and DIP3 are
programmed to
OFF
. It is required to connect
the RI input to an output that follows the Arm/
Disarm status of the panel and gives Negative
(0v/-/GND) when disarmed and Positive
(COM/+/12v) when armed.
7. Buzzer Alarm
OFF = Anti-mask enabled only
system disarmed (see DIP4)
6. Open Mask and Alarm Relays
5. Sensitivity
OFF
= Mask relay open
ON
= Buzzer Enabled
OFF
= Buzzer Disabled
ON
= Mask & alarm relays open
8. LED Enable/Disable
ON
= Auto Sensitivity
OFF
= High Sensitivity
ON = LED Enabled (Remote LED disabled)
OFF
= LED Disabled (Remote LED enabled)
To remotely enable the LEDs:
Connect LED to walk test PGM: 0V = Walk Test On. 12V = Walk Test Off
5. Dip Switch Programming
1. 50/60Hz AC Filter
ON
= 50Hz.
OFF
= 60Hz (For use with AC supplies at 60Hz)
2. Anti-Mask Operation
ON
= Anti-mask enabled