Page: 4
3.2
Inside of the Home Panel: Rear
1.
Terminals for Earth and Mains Supply. See
page: 3.
2.
If a modem is required (DIGI-GPRS, DIGI-LAN),
this is where it must be mounted. See page: 16
3.
The transformer is situated in a housing.
There should be no need to remove this
housing.
4.
The rear tamper adjustment screw is used if
the tamper from the front of the Home
Panel is not sitting flush to the back plate. This
may happen if the Home Panel is
installed on an uneven surface.
5.
If an I/O board is installed, then this space is
used to install it. See page: 8
3.3
Inside of the Home Panel: Front
1.
RS232 connection for up/downloading to the InSite
software. (see the programming reference manual for
more details).
2.
The location of the control panel battery.
See page 5 for replacement procedure.
3.
The power connection for a DIGI-GPRS if connected
(Note that this port is labeled ‘GSM MODEM’). See
page: 16
4.
The connection for an I/O board if connected.
See
page: 8
5:
The connection for the modem installed (DIGI-
GPRS, DIGI-LAN, DIGI-WiFi ). See page: 16 onwards
6:
The power connection (+12V DC) for the
Home Panel.
Summary of Contents for HomeControl+
Page 1: ......
