EN
52
Operating Manual: XSD200 - Smoke Alarm Device with Radio Link
Operating Manual: XSD200 - Smoke Alarm Device with Radio Link
EN
53
EN
EN
Splint pin (activation backup)
The splint pin (activation backup) is used
during the transport of the device to pro-
tect against accidental activation.
After activating the device, the splint pin
(activation backup) is used as a tool for
operating the radio button, and must be
kept readily available in the vicinity of
the device.
Activation button
The activation button is used to turn the
device on and off.
Magnet carrier
The magnet carrier is used for fastening
the device.
Signal LED
The signal LED displays results and in-
termediate results during start-up of de-
vices and setting up of radio groups or
shared radio groups.
Radio button
The radio button is found in the opening
marked with an arrow. It is used to set up
the radio connection between devices.
Smoke intake lamellas
Smoke from the fire reaches the inside
of the device through the smoke intake
lamellas and can then be detected by
sensors.
Testing/stop button
(smoke alarm device cover)
The testing/stop button (smoke alarm
device cover) is used for a self-test, for
correct wireless connection between
multiple devices or between devices of
a radio group.
The testing/stop button (smoke alarm
device cover) can be pressed to interrupt
or stop alarm and alert tones.
4 Location selection
EN
50
Operating Manual: FRWM200 – Smoke Alarm Device with Radio Link
*
*
*
*
Fig. 2
Location selection
Minimum equipment
Optimal equipment
Required by law in Berlin
and Brandenburg
Conditional
Do not install due to
steam
Escape route
Attic
Guest room
Bedroom
Children´s
bedroom
Livingroom
Kitchen
Heating
Workroom
Bedroom
Bath-
room
Kitchen
Corridor
Livingroom
Children´s
Bedroom
Children´s
Bedroom
Top
floor
Upper
floor
Ground
floor
Cellar
4 Location selection
Office
Fig. 11 Location selection
