power is restored, the display will light up again and alarm time set previously is restored. The battery will
maintain timekeeping for approximately 8 hours during power failure or interruption.
•
The unit can also be operated by batteries during power failure.
•
1 x 9 Volt batteries required (not included).
•
Flat batteries should be removed from compartment to avoid leakage.
•
Batteries shall not be exposed to excessive heat such as sunshine, fire or like.
•
Replace the old batteries with new ones when the sound becomes unstable or cannot be heard.
NOTE: Remove the battery if the unit is to be unplugged for a long period of time, avoiding unnecessary battery
drain.
TIME SETTING
Press and hold the time “SET/ PRE/ M+” (4), then the clock display (8) will blink. Press the “HOUR/ TU-” (2),
“MIN/ TU+” (3) or to set the hour and min of the clock display respectively to the correct time. Press “SET/ PRE/
M+” (4) again when finished the setting, the time display will not blink.
NOTE:
PM is indicated by light on “PM” in the display.
DIMMER HI/ LOW
On time display mode, press “DIMMER HI/ LOW” (7) to set hi or low of the LED display.
RADIO OPERATION
Press
“AM/ FM/ ON/ OFF” (1) once, it will turn on the radio, press “AM/ FM/ ON/ OFF” (1) again to select AM
band or FM band. Press
“MIN/ TU+” (3) or “HOUR/ TU-“ (2) to adjust your desired frequency. Press “AL 2/
VOL+” (6) to increase the volume, press “AL 1/ VOL-” (5) to decrease the volume.
Frequency:
FM 87.5
– 108 MHz
AM 522
– 1620 KHz
Clock Display:
12 Hour
MEMORY OPERATION
This clock radio can store 10AM and 10FM pre-sets. On radio playing mode, select your desired band (AM/FM)
press up
“MIN/ TU+” (3) or “HOUR/ TU-” (2) to choose your desired frequency, hold down and press “SET/ PRE/
M+” (4) to enter into the pre-set mode. The pre-set number will show and flash on the LED Display (8), then
short press
“HOUR/ TU-“ (2) or “MIN/ TU+” (3) to select your desired memory numbers from P1 to P10. Press
the “SET/ PRE/ M+” (4) to confirm your memory setting. Repeat the above steps, you can store your desired
