5.14.2
Error message
The device is equipped with a built-in memory work control function.
If there are problems with the memory operation on the PX745 display, the
Err
message appears – memory error.
In this situation, select the “
enter
” key. The device will reload the default
configuration and upload it to the memory. If after this operation, the
Err
message remains on the screen, the memory is permanently damaged and
the unit must be sent to the service point.
6
DMX signal connecting
PX745 have to be connected to DMX line in serial mode, with no branches
on DMX control cable. That means that DMX line, from the signal source,
must be connected to
DMX IN
pins of PX745 and later, directly from
DMX OUT
pins to the next device in DMX chain.
If the PX745 is the last DMX chain receiver there should be terminator
(resistor 120 Ohm) mounted between "
DMX+
" and "
DMX-
" pins of
DMX OUT
section.
DMX IN
DMX OUT
-
-
+
+
GND
GND
CORRECT
DMX-512 input
DMX-512 output
DMX IN
DMX OUT
-
-
+
+
GND
GND
WRONG
DMX-512 line
DMX IN
DMX OUT
-
-
+
+
GND
GND
TERMINATOR CONNECTION
DMX-512 input
120 Ohm
26