To remove the device, press it from
the top, and then tilt the bottom of
the device towards you. Finally,
moving the whole device up slightly
can be removed.
11 Connection scheme
MultiSystem Dimmer must be connected to the DMX line in series. That
means, the control cable must be driven to the DMX coupling of the dimmer,
and then driven out from the same coupling (refer to the scheme below) to the
next DMX-512 signal receivers.
If MultiSystem Dimmer is installed as the last device in a DMX line, a
terminator (120 Ohm resistor) must be connected to “DMX+” and “DMX-”
terminals.
In addition, when, instead of potentiometers, the monostable button is to
be applied, it must be connected to “+10V OUT” and “0 – 10V IN” inputs.
26
1
2
GND
DMX-
DMX+
DMX cable
CORRECT
WRONG
120 Ohm
DMX cable