6
6. MASTER / SLAVE FEATURE
The PX307 driver is equipped with DMX-512 signal receiver and can be controlled with any DMX
desktop. In addition, the unit has a built-in programmable reaction to DMX signal interruption
(noS). By dint of 18 factory-defined programs you can obtain interesting effects without the
external controller. In case of using
the complex installations realizing the same
sequence cannot guarantee the full playing synchronization. That is why the driver is provided
with the MASTER feature. When this feature is active, the module becomes the DMX signal
transmitter and sends to all the other modules (set as SLAVES, DMX signal receivers) the
realized program. Thanks to such a solution the precise synchronization, even in very complex
installations, is possible.
few PX307 in
To turn the MASTER feature on enter the C-d
menu
"
"
Press enter button to set a
Con option on the display.
"
"
To choose the number of DMX
channels to be sent from PX307 You
need to enter the Chn menu.
"
"
ENTER
ENTER
ENTER
NEXT
NEXT
You can activate Master
function by setting it "on"
or "oFF”
You can choose from
range from 24 to 512.
NEXT
CAUTION:
PX307 basically sends three channels (R, G, B), but because the DMX standard defines the
minimal emited channels number as 24, these three channels are duplicated eight times. If there
is such a necessity, you can multiplicate them up to 512 channels (this setting is not
recommended because of the decrease of a transmission speed).
ENTER
NEXT
3x
5. DMX ADDRESS SETTING
The menu of the PX307 driver allows for setting the DMX address within a range between 1 and
510. The driver occupies three consecutive DMX addresses. If address is set to 510, the last
channel is occupied by address 512.
To set the DMX address:
1. Select Adr menu.
2. With "next" or "previous" buttons set the required DMX address.
1
2
NEXT
ENTER
ENTER
