8
6. Locate the inverter mounting hole below the power board (see Figure
3-3). Insert the mounting screw through the inverter and tighten
securely.
Models PVP4600, PVP4800 and PVP5200
1. Locate the wall studs in the desired location and align the mounting
bracket or paper mounting template over the studs. Mark the mounting
holes. Ensure that locations A and B in the following figure are aligned
over two wall studs.
2. VERIFY THE BRACKET IS LEVEL. Ensure points A and B are
aligned with the wall studs. Drill 1/8” pilot holes for the screws.
• Use heavy-duty 1/4” x 2” (.635 cm 5 cm) coarse thread lag screws
to secure points A and B to the wall.
• Use an 1/8” (.32 cm) screw (and anchor if necessary) to secure
point C.
Figure 3-2 Large Mounting Bracket
3. Carefully hang the inverter/disconnect unit on the upper part of the
bracket. The hooks located at the rear of the inverter should hang over
the bracket.
4. Verify the inverter/disconnect unit is level.
5. Remove the front lid of the inverter by unscrewing the four screws
located around the front perimeter of the inverter.
6. Locate the inverter mounting hole below the power board (see Figure
3-3). Insert the mounting screw through the inverter and tighten
securely.
B
A
C
