12. OPERATIONS AND SETTINGS
OPERATIONS AND SETTINGS
BATTERY SAVE
This function can decrease power consumption when no signal is received. and no operation is
perfo- rmed.
You can use programming software to open or close this function.
END ROGER
It's prompting signal transmit finshed. You can use programming software to open or close this
function.
SQUELCH TALL ELIMINATION
It can elimianate the end roger beep. For wearing headphone users, tail elimination is very
clearly. You can use programming software to set this function.
LOW BATTERY WARNING
Low battery warning alerts you that the battery should be recharged or replaced. While
transmitting or receiving, the LED will blink red if the battery is low. it will remind "Low
Voltage" at interval 30 seconds, if turn off the voice function, sound "DU DU DU" prompt.
13. OPERATIONS AND SETTINGS
CABLE CLONE
Step:
1. Use cable to connect Master unit to slave unit, and turn on the slave unit. Press and hold
program- mable Side Key 2 to turn ON master unit, LED flash Orange twice into clone statue.
2. Press PTT of Master unit to transmit the data and Slave unit begin to receive data from Master
unit
3. During cable cloning Master unit blink red and Slave unit blink Green
4. When cloning completed, slave unit restart automatically.
5. Switch to next slave unit and power on, press side key 2 of master unit to clone.
6. Power off master unit to exit.
◆
During data transmission, if no data received 3 seconds Master unit flash Red (0.5s ON, 0.5S
OFF)
PTT ID TRANSMIT MODE
1. Press PTT to send. 2. Release PTT to end. 3. Both. 4. OFF
◆
OFF: Press PTT or release it will not send ANI code.
◆
PRE-ONLY: Press PTT to send the ANI.
◆
POST-ONLY: Release PTT to send the ANI.
◆
BOTH: Both press and release PTT to send ANI.
THE SIDE KEY CAN BE PROGRAMMED THE FUNCTIONS AS FOLLOW,
1. NONE 2. MONITOR 3. SCAN ON/OFF 4. HIGH/LOW POWER
5. TALK AROUND 6. REVERSE 7. PRIORITY SCAN 8. VOX ON/OFF
