128-4088D
2 OF 7
YOUR KEYCHAIN TRANSMITTERS:
The transmitters included with this security system are pre-programmed at the
factory, with button assignments (channels) prioritized in a standard format. You
can select which transmitter button controls a particular function, (see the transmit-
ter programming guide).
This manual explains the operation of the system assuming that the transmitter
buttons are prioritized in their standard, factory pre-set format.
1. Turn off the engine. exit the vehicle, and close and lock all doors, hood, and
trunk.
2. The dash mounted L.E.D. will begin to flash rapidly, indicating that the system
is automatically (passive) arming. As an added convenience, the automatic
passive arming will not begin until all doors and trunk lid are closed, allowing
passengers to exit the vehicle at their convenience.
3. In 30 seconds, you will hear a single short "chirp" from the siren, and the vehicle's
parking lamps will flash one time, indicating the system is ARMED. At this time,
the dash mounted L.E.D. will begin to flash slowly, providing a visual indication
that the system is fully ARMED.
OPTION NOTE: If the optional (not included) power door lock interface
has been installed, the alarm control module can be programmed to...
a) Automatically lock the doors during step 3 above, or,
b) Only lock the doors when step 4 is executed.
3. You will hear a single short "chirp" from the siren, and the vehicle's parking lamps
will flash one time, indicating the system is ARMED. At this time, the dash
mounted L.E.D. will begin to flash slowly, providing a visual indication that the
system is fully ARMED.
3A. If the optional door lock interface has been installed, the doors will automatically
lock when the system is armed.
NOTE: If the siren "chirped" three times when ARMING, then one of the entry
points (hood, trunk, doors) has been left opened. Closing the hood, trunk, or
doors will correct the problem, and you do not need to disarm the system to
make the correction.
1. Turn off the engine, exit the vehicle, and close and lock all doors, hood, and trunk.
2. Momentarily depress button 1 on the keychain transmitter.
WARNING! Excessive pressure on the transmitter buttons will damage
the internal components on the circuit board. All that is required is a light
push to the button.
ARMING THE SYSTEM (CHANNEL 1) : ACTIVE
ARMING THE SYSTEM (CHANNEL 1) : PASSIVE
