PURSUIT 2870 OFFSHORE, Owner'S Manual

Page: 21 / 132

2870 OFFSHORE
21
Chapter 2:
HELM SYSTEMS
2.1 General
The helm controls consist of three systems: the engine throttle and shift controls, the steering system and the
trim tab control switches.
Each manufacturer of the control components provides an owner’s manual with its product. It is important
that you read the manuals and become familiar with the proper care and operation of the control systems.
2.2 Helm Access
The helm and engine controls are located on an opening helm station. The helm station is hinged at the bottom
and opens to provide access to service the helm equipment. To open the helm station, slide the seat back, tilt
the steering wheel to the full upright position and open the two latches that secure the helm in place. A strap
holds the helm in the open position. To secure the helm in place, close the helm and secure the two latches.
ALWAYS MAKE SURE THE HELM STATION IS PROPERLY SECURED BEFORE OPERAT-
ING OR TRANSPORTING YOUR BOAT. IF THE HELM STATION IS NOT PROPERLY SE-
CURED, IT COULD OPEN UNEXPECTEDLY AND DAMAGE THE BOAT OR CAUSE LOSS
OF CONTROL.
UNDER NO CIRCUMSTANCES SHOULD THE HELM BE OPENED WHEN THE ENGINE(S)
ARE RUNNING. IN SOME SITUATIONS IT IS POSSIBLE TO ACCIDENTALLY ENGAGE
THE ENGINE SHIFT INTO GEAR AND/OR ADVANCE THROTTLE CONTROLS AS THE
HELM IS OPENING. THIS COULD RESULT IN LOSS OF CONTROL, DAMAGE TO THE
BOAT, AND INJURY TO PASSENGERS.
2.3 Engine Throttle and Shift Controls
The shift and throttle controls on your boat may vary depending on the engines used.
The following control description is typical of most outboard remote controls. Refer
to the engine or control manuals for specific information on the controls installed on
your Pursuit.
The helm on your Pursuit is designed for a binnacle style control with a single lever
for each engine that operates as a gear shift and a throttle. General operation will
include a position for neutral (straight up and down), a forward position (the 1st
detent forward of neutral), and a reverse position (the 1st detent aft of neutral).
Advancing the control lever beyond the shift range advances the throttle in forward
or reverse. Each control is equipped with a means of permitting the engine to be
operated at a higher than idle RPM while in neutral for cold starting and warm-up
purposes.
Controls