PURSUIT 2870 OFFSHORE, Owner'S Manual

Page: 82 / 132

2870 OFFSHORE
82
THERE MUST BE AT LEAST ONE PERSONAL FLOTATION DEVICE ON BOARD FOR EV-
ERY PERSON ON BOARD AND ONE THROW-OUT FLOTATION DEVICE. CHECK THE
U.S. COAST GUARD STANDARDS FOR THE CORRECT TYPE OF DEVICE FOR YOUR BOAT.
• Make sure you have signal kits and flare guns aboard, and they are current and in good operating condition.
• Be sure you have sufficient water and other provisions for the planned cruise.
• Leave a written message listing details of your planned cruise with a close friend ashore (Float Plan). The
float plan should include a description of your boat, where you intend to cruise, and a schedule of when
you expect to arrive in the cruising area and when you expect to return. Keep the person informed of
any changes in your plan to prevent false alarms. This information will tell authorities where to look and
the type of boat to look for in the event you fail to arrive.
• Check the amount of fuel on board. Observe the “rule of thirds”: one third of the fuel for the trip out,
one third to return and one third in reserve. An additional 15% may be consumed in rough seas.
• Check the water separating fuel filters for water.
• Turn on the battery switches.
• Check the bilge water level. Look for other signs of potential problems. Monitor for the scent of fuel
fumes.
• Test the automatic and manual bilge pump switches to make sure the system is working properly.
• Have a tool kit aboard. The kit should include the following basic tools:
Spark Plug Wrench Hammer
Spark Plug Gap Gauge Electrician’s Tape
Screwdrivers Lubricating Oil
Pliers Jackknife
Adjustable Wrench Vise Grip Pliers
Needle Nose Pliers Wire Crimping Tool
End Wrench Set Wire Connector Set
• Have the following spare parts on board:
Extra Light Bulbs Spark Plugs
Fuses and Circuit Breakers Flashlight and Batteries
Drain Plugs Engine Oil
Propellers Fuel Filters
Propeller Nuts Fuel Hose and Clamps
• Make sure all fire extinguishers are in position and in good operating condition.
BE SURE THE SHIFT CONTROL IS IN THE NEUTRAL POSITION.